Error in step one of Assembly
Posted: 16 Nov 2018, 22:24
Step one is putting all the capacitors in, it then goes on to say "Check that there is no short circuit, by measuring the resistance between the +5V and Ground pins on the USB connector"
But USB connector +5V does not go anywhere at this point as there is no F1 in the circuit so even if you have a short circuit you will not see it measuring at the point.
You need to do the check between 0V and the other side of F1.
Peter.
But USB connector +5V does not go anywhere at this point as there is no F1 in the circuit so even if you have a short circuit you will not see it measuring at the point.
You need to do the check between 0V and the other side of F1.
Peter.