arduino nano and bablefish
Posted: 28 Mar 2019, 00:30
so I have an arduino nano connected to the DB9, and its running babelfish, I get the serial output, that shows the gigtron is OK.. I tell it to load a build in program as a test and it says it loads and executes but it does not..
reset command and keyboard input are not working as well..
this is V2 bios
not sure why.. if its says its ok is it not talking to the board?
reset command and keyboard input are not working as well..
this is V2 bios
Code: Select all
Gigatron OK
Cmd?
:Echo on
:Gigatron OK
Cmd?
H
:Commands are
: V Show configuration
: H Show this help
: R Reset Gigatron
: L Start Loader
: M Show key mapping or menu in Loader screen
: P[<n>] Transfer object file from PROGMEM slot <n> [1..12]
: U Transfer object file from USB
: .<text> Send text line as ASCII key strokes
: C Toggle echo mode (default off)
: T Enter terminal mode
: W/A/S/D Up/left/down/right arrow
: Z/X A/B button
: Q/E Select/start button
:Gigatron OK
Cmd?
A
:Gigatron OK
Cmd?
D
:Gigatron OK
Cmd?
D
:Gigatron OK
Cmd?
M
:Gigatron OK
Cmd?
M
:Gigatron OK
Cmd?
P1
:Loading 11 bytes at $7F00
:Executing from $7F00
:Gigatron OK
Cmd?
not sure why.. if its says its ok is it not talking to the board?