Hello! I made a Gigatron

A place to eternalise your Gigatron build photos. From box to BASIC.
Forum rules
Use this forum to show off your build photos. For build issues, please consult the directions in the sticky post on top instead.
Post Reply
Mr Tall
Posts: 7
Joined: 20 Feb 2024, 21:05

Hello! I made a Gigatron

Post by Mr Tall »

This was made by ordering PCBs from JLPCB in China, and sourcing all the bits from Farnell, Mouser and Digikey:
IMG_20240207_213438.jpg
IMG_20240207_213438.jpg (3.01 MiB) Viewed 15441 times
It works!
IMG_20240209_174156.jpg
IMG_20240209_174156.jpg (3.19 MiB) Viewed 15441 times
Sort of. I've hacked up a knock-off SNES controller to the 9 pin port. The Gigatron just acts like lots of random inputs are being pressed, and nothing I do on the controller makes any difference. I'll write up a post on the support page for this.

Anyway, hello!
at67
Site Admin
Posts: 653
Joined: 14 May 2018, 08:29

Re: Hello! I made a Gigatron

Post by at67 »

Welcome and congratulations, there are many threads about controllers, SW, HW and the different types supported, I would do a quick search if I was you.
bmwtcu
Posts: 152
Joined: 01 Nov 2018, 12:02

Re: Hello! I made a Gigatron

Post by bmwtcu »

Are you able to tell what IC the knock off controller uses inside? I'm assuming it's hidden under a glob top. If you have the parts handy, it's fairly trivial to build a CD4021B or 74xx165 based NES controller if you want a guarantee of compatibility.

https://www.raphnet.net/electronique/ar ... rol_en.php
https://github.com/BenBergman/uJoypad/t ... /schematic
Mr Tall
Posts: 7
Joined: 20 Feb 2024, 21:05

Re: Hello! I made a Gigatron

Post by Mr Tall »

It's not potted, but it doesn't seem to have any markings.
IMG_20240221_195501.jpg
IMG_20240221_195501.jpg (2.28 MiB) Viewed 15398 times
I do like the custom "SECECT" button though, not seen that before :)

Thanks for the links - I've got some alternative controllers on the way from AliExpress, but I'll go dig through my bits box and see if I've got any 74LS165s lurking around.
Mr Tall
Posts: 7
Joined: 20 Feb 2024, 21:05

Re: Hello! I made a Gigatron

Post by Mr Tall »

Received some "famiclone" controllers from AliExpress, and they *sort of* work. The Gigatron recognises input from these, but causes one of my monitors to go black when it's plugged in. Random unplugging/plugging back in can make it come back to life some of the time.

So, an 74LS165 from eBay (made in W.Germany!), a bit of breadboard, some resistors and a spare 74HC04 inverter, and I've knocked up a controller circuit that works perfectly. No screen blanking at all with this. Playing Snake by touching a ground wire to resistor legs is a bit too hard though :)

Just need to 3D print a box and solder up some switches. I guess the "Famiclone" controller was interfering with the H/V sync signals too much for my old monitor to cope with.
Post Reply